ASTM C1103-22
Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines
- Standard No.
- ASTM C1103-22
- Release Date
- 2022
- Published By
- American Society for Testing and Materials (ASTM)
- Latest
- ASTM C1103-22
- Scope
- 1.1 This practice covers procedures for testing the joints of installed precast concrete pipe sewer lines, when using either air or water under low pressure to demonstrate the integrity of the joint and the construction procedures. This practice is used for testing precast concrete sewer lines utilizing rubber gasket sealed joints. NOTE 1—The user of this practice is advised that methods described herein may also be used as a preliminary test to enable the manufacturer or installer to demonstrate the condition of sewer pipe prior to delivery. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. NOTE 2—The owner shall specify the following: who will conduct, observe, and furnish labor, material, and measuring devices and pay for the tests; who is responsible for determining local ground conditions; and whether an air or water test is to be used. NOTE 3—The user of this practice is advised that test criteria presented in this practice are similar to those in general use. Pipe shall be accepted by infiltration or exfiltration testing utilizing Practice C969 (C969M). NOTE 4—Test times tabulated and the rate of air loss in this practice are based on successful testing of installed pipelines. However, since air and water have different physical properties, retests of some pipelines not meeting field air tests have been successful when tested with water. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautions are given in Section 6. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM C1103-22 Referenced Document
- ASTM C822 Standard Terminology Relating to Concrete Pipe and Related Products
- ASTM C969 Standard Practice for Infiltration and Exfiltration Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines
- ASTM C969M Standard Practice for Infiltration and Exfiltration Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines (Metric)
ASTM C1103-22 history
- 2022 ASTM C1103-22 Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines
- 2019 ASTM C1103-19 Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines
- 2014 ASTM C1103-14 Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines
- 2003 ASTM C1103-03(2009) Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines
- 2003 ASTM C1103-03 Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines
- 2002 ASTM C1103-02 Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines
- 1994 ASTM C1103-94(2000) Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines
