What is BS EN 16486 about?
BS EN 16486 specifies the safety requirements for the design, manufacture, and information for the safe use of compactors that compact waste material or recyclable fractions (e. g., paper, plastics, textiles, cans, cardboard, mixed waste), hereafter referred to as materials.
BS EN 16486 applies to:
Compactors using a horizontally moving screw, pendulum, or plate as compacting part and where the materials move horizontally
Compactors that are mechanically fed and/or fed by hand
These compactors can be
Static compactors
Transportable compactors
Traversing systems
The scope includes:
Any integral mechanical feed equipment (e.g., Bin lift)
Feed hoppers/openings
Any integral pre-conditioning equipment in the hopper (e.g., Perforators, pre-crushing devices and shredders)
Any integral material flow control equipment
The interface between the compactor and any feed equipment (except those excluded from the scope)
All hazards mentioned in Clause 4 are dealt with in this European Standard.
Note-
The scope of BS EN 16486 does not cover:
Compactors that are covered by EN 1501 (all parts);
Underground compactors, however, if these compactors can be used above ground this standard applies
Compactors using thermal technologies for compaction
Vacuum compactors
Compactors where materials are compacted vertically
Containers for static compactors, however the interface between the compaction unit and the container is included
Bins in which materials are collected for feeding into the compactor
Any up-stream pre-trea...
BS EN 16486:2014+A1:2020 history
2020BS EN 16486:2014+A1:2020 Machines for compacting waste materials or recyclable fractions. Compactors. Safety requirements
2014BS EN 16486:2014 Machines for compacting waste materials or recyclable fractions. Compactors. Safety requirements