ASTM D4695-03(2015)
Standard Guide for General Pavement Deflection Measurements

Standard No.
ASTM D4695-03(2015)
Release Date
2015
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM D4695-03(2020)
Latest
ASTM D4695-03(2020)
Scope
1.1 This guide provides procedural information for measuring pavement surface deflections, directly under, or at locations radially outward (offset) from a known static, steady-state, or impulse load. Deflections are measured with sensors that monitor the vertical movement of a pavement surface due to the load. This guide describes procedures for the deflection measurement using various deflection testing devices and provides the general information that should be obtained regardless of the type of testing device used. 1.2 This guide is applicable for deflection measurements performed on flexible asphalt concrete (AC), rigid portland cement concrete (PCC), or composite (AC/PCC) pavements. Rigid pavements may be plain, jointed, jointed reinforced, or continuously reinforced concrete. 1.3 The values stated in SI units are to be regarded as standard. Inch-pound units given in parentheses are for information purposes only. 1.4 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D4695-03(2015) Referenced Document

  • ASTM D4602 Standard Guide for Nondestructive Testing of Pavements Using Cyclic-Loading Dynamic Deflection Equipment
  • ASTM D4694 Standard Test Method for Deflections with a Falling-Weight-Type Impulse Load Device
  • ASTM D5858 Standard Guide for Calculating In Situ Equivalent Elastic Moduli of Pavement Materials Using Layered Elastic Theory

ASTM D4695-03(2015) history

Standard Guide for General Pavement Deflection Measurements



Copyright ©2024 All Rights Reserved