ASTM D3863-22 PDF

Scope: 1.1 This test method covers a procedure to test membrane filters for their ability to retain bacteria whose diameter is equal to or slightly larger than membrane filters with pore size rated at 0.40 to 0.45 µm. 1.2 The procedures described are for the use of user laboratories as differentiated from manufacturers’ laboratories. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3863-22 Referenced Document

2022 ASTM D3863-22 Standard Test Method for Retention Characteristics of 0.40 to 0.45 μm Membrane Filters Used in Routine Filtration Procedures for the Evaluation of Microbiological Water Quality
1987 ASTM D3863-87(2011) Standard Test Method for Retention Characteristics of 0.40 to 0.45-181m Membrane Filters Used in Routine Filtration Procedures for the Evaluation of Microbiological Water Quality
1987 ASTM D3863-87(2003) Standard Test Method for Retention Characteristics of 0.40 to 0.45-181m Membrane Filters Used in Routine Filtration Procedures for the Evaluation of Microbiological Water Quality
1987 ASTM D3863-87(1998) Standard Test Method for Retention Characteristics of 0.40 to 0.45-181m Membrane Filters Used in Routine Filtration Procedures for the Evaluation of Microbiological Water Quality