1.1 This test method covers the determination of the permanent linear change of refractory brick when heated under prescribed conditions.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. NOTE 1—Test methods incorporating additional provisions pertinent to specific refractory materials are given in the following Test Methods: C179, C210, and C605.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM C113-14(2019) Referenced Document
ASTM C134 Standard Test Methods for Size, Dimensional Measurements, and Bulk Density of Refractory Brick and Insulating Firebrick*, 2023-08-03 Update
ASTM C179 Standard Test Method for Drying and Firing Linear Change of Refractory Plastic and Ramming Mix Specimens
ASTM C210 Standard Test Method for Reheat Change of Insulating Firebrick