PP 61-2010
Standard Practice for Developing Dynamic Modulus Master Curves for Hot Mix Asphalt (HMA) Using the Asphalt Mixture Performance Tester (AMPT) (Revision 1)

Standard No.

PP 61-2010

Release Date

2010

Published By

AASHTO - American Association of State Highway and Transportation Officials

Status

Be replaced 2017-09

Replace By

PP 61-2013

Latest

PP 61-2013

Scope

This practice describes testing and analysis for developing a dynamic modulus master curve for hot mix asphalt (HMA) using the Asphalt Mixture Performance Tester (AMPT). This practice is intended for dense- and gap-graded mixtures with nominal-maximum aggregate sizes up to 37.5 mm. This practice accounts for the temperature limitations of the AMPT and provides guidance to the user for the selection of appropriate test temperatures. This standard may involve hazardous materials@ operations@ and equipment. This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PP 61-2010 history

• 2013 PP 61-2013 Standard Practice for Developing Dynamic Modulus Master Curves for Asphalt Mixtures Using the Asphalt Mixture Performance Tester (AMPT)
• 2010 PP 61-2010 Standard Practice for Developing Dynamic Modulus Master Curves for Hot Mix Asphalt (HMA) Using the Asphalt Mixture Performance Tester (AMPT) (Revision 1)
• 2009 PP 61-2009 Standard Practice for Developing Dynamic Modulus Master Curves for Hot Mix Asphalt (HMA) Using the Asphalt Mixture Performance Tester (AMPT)