This standard is intended to provide a method to obtain repeatable measurements that accurately reflect true engine performance in customer service. Whenever there is an opportunity for interpretation of the standard@ a good faith effort shall be made to obtain the engine's typical in-service performance and avoid finding the best possible performance under the best possible conditions. Intentional biasing of engine component or assembly tolerances to optimize performance for this test is prohibited. Purpose of Standard This SAE Standard has been adopted by SAE to specify: a. A basis for net engine power and torque rating b. Reference inlet air and fuel supply test conditions c. A method for correcting observed power and torque to reference conditions d. A method for determining net full load engine power and torque with a dynamometer e. A procedure to ensure that engine controls are operating in a manner consistent with customer operation. Field of Application This test code document is applicable to both spark ignition (SI) and compression ignition (CI) engines@ naturally aspirated and pressure-charged@ with and without charge air cooling. This document does not apply to aircraft or marine engines. The standard is applicable to the internal combustion engine used in a hybrid powertrain@ but it does not comprehend the combined output of the hybrid powertrain. This test code supersedes those portions of SAE J1349 JUN1995 dealing with net power rating. It can be used immediately@ and it shall be used for testing after January 1@ 2005. Standard CI diesel fuel specifications are range mean values for Type 2-D EPA test fuel per Title 40@ Code of Federal Regulations@ Part 86.1313-2004 or most recent. The corresponding test code for gross power and torque rating is SAE J1995. The document for mapping engine performance is SAE J1312. Relationship to ISO 1585 ISO 1585-1992 differs from SAE J1349 in several areas@ among which the most important are: a. This document is not limited to road vehicles. b. This document requires inlet fuel temperature be controlled to 40 ??on CI engines. c. This document includes a reference fuel specification and requires that engine power be corrected to that specification on all CI engines. d. This document includes a different procedure for testing engines with a laboratory charge air cooler. e. This document stipulates a 20% duty cycle limit on variable speed cooling fans in order to qualify for testing at the minimum power loss settings. f. This document provides procedures for transient testing of light duty vehicles with the associated changes in control parameters and exhaust back pressure. g. This document includes accessory losses if the accessories are standard on the vehicle application. h. ISO 1585-1992 allows ??7% correction on SI and ??10% correction on CI engines.
SAE J1349-2008 history
2011SAE J1349-2011 Engine Power Test Code Spark Ignition and Compression ignition As Installed Net Power Rating
2008SAE J1349-2008 Engine Power Test Code—Spark Ignition and Compression Ignition—Net Power Rating
2004SAE J1349-2004 Engine Power Test Code Spark Ignition and Compression Ignition Net Power Rating R(2000)
1995SAE J1349-1995 ENGINE POWER TEST CODE—SPARK IGNITION AND COMPRESSION IGNITION—NET POWER RATING
1990SAE J1349-1990 Engine Power Test Code Spark Ignition and Compression Ignition Net Power Rating R(2000)
1985SAE J1349-1985 Engine Power Test Code - Spark Ignition and Diesel
1983SAE J1349-1983 Engine Power Test Code - Spark Ignition and Diesel
1980SAE J1349-1980 Engine Power Test Code - Spark Ignition and Diesel