SAE MAM2261D-2007
Tolerances@ Metric Nickel@ Nickel Alloys@ and Cobalt Alloy Bars@ Rods@ and Wire
- Standard No.
- SAE MAM2261D-2007
- Release Date
- 2007
- Published By
- SAE - SAE International
- Status
- 2007-07
- Replace By
- SAE MAM2261-2011
- Latest
- SAE MAM2261-2011
- Scope
- "This specification covers established metric manufacturing tolerances applicable to bars@ rods@ and wire of nickel@ nickel alloys@ and cobalt alloys ordered to metric dimensions. These tolerances apply to all conditions@ unless otherwise noted. The term ""excl"" is used to apply only to the higher figure of a specified range. Throughout this specification@ the term ""metric"" is intended to refer to the SI system. These tables are based upon logical metric values and preferred metric sizes. Where the terms ""nickel""@ ""nickel-copper""@ ""nickel-chromium""@ ""nickel-molybdenum""@ ""nickel-molybdenum-chromium""@ and ""cobalt"" are used without qualification@ they refer to both non-heat-treatable and heat-treatable alloys as applicable@ unless otherwise noted. AMS 2261@ specified in inch/pound units@ is the equivalent of this MAM. "
SAE MAM2261D-2007 history
- 2011 SAE MAM2261-2011 Tolerances, Metric, Nickel, Nickel Alloys, and Cobalt Alloy Bars, Rods, and Wire
- 2007 SAE MAM2261D-2007 Tolerances@ Metric Nickel@ Nickel Alloys@ and Cobalt Alloy Bars@ Rods@ and Wire
- 2003 SAE MAM2261C-2003 (Noncurrent)Tolerances, Metric Nickel, Nickel Alloys, and Cobalt Alloy Bars, Rods, and Wire
- 1994 SAE MAM2261A-1994 TOLERANCES, METRIC Nickel, Nickel Alloys, and Cobalt Alloy Bars, Rods, and Wire
- 1990 SAE MAM2261A-1990 Tolerances@ Metric Nickel@ Nickel Alloy@ and Cobalt Alloy Bars@ Rods@ and Wire
