1 Scope
This document specifies the requirements and test methods for solid flat extruded
sheets of polypropylene homopolymers (PP‑H) and polypropylene copolymers (PP‑B and
PP‑R) without fillers or reinforcing materials. This document applies to PP sheet
in rolled form. It applies only to thicknesses of 0,5 mm to 40 mm.
BS EN ISO 15013:2022 Referenced Document
ISO 1133-1 Plastics — Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics — Part 1: Standard method*, 2022-06-23 Update
ISO 11501 Plastics - Film and sheeting - Determination of dimensional change on heating
ISO 179-1 Plastics. Determination of Charpy impact properties - Non-instrumented impact test*, 2023-06-07 Update
ISO 179-2 Plastics — Determination of Charpy impact properties — Part 2: Instrumented impact test — Amendment 1: Precision data
ISO 19069-1 Plastics - Polypropylene (PP) moulding and extrusion materials - Part 1: Designation system and basis for specifications
ISO 2818 Plastics — Preparation of test specimens by machining
ISO 291 Plastics - Standard atmospheres for conditioning and testing
ISO 4577 Plastics — Polypropylene and propylene-copolymers — Determination of thermal oxidative stability in air — Oven method
ISO 527-2 Plastics - Determination of tensile properties - Part 2: Test conditions for moulding and extrusion plastics
BS EN ISO 15013:2022 history
2022BS EN ISO 15013:2022 Plastics. Extruded sheets of polypropylene (PP). Requirements and test methods
2007BS EN ISO 15013:2007 Plastics - Extruded sheets of polypropylene (PP) - Requirements and test methods