ASTM F205-94(2020) PDF

Scope: 1.1 This test method covers the measurement of the average diameter of fine wire by weighing a known length; it applies particularly to sizes up to 0.13 mm used in electron devices and lamps. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM F205-94(2020) Referenced Document

ASTM F180 Standard Test Method for Density of Fine Wire and Ribbon Wire for Electronic Devices

2020 ASTM F205-94(2020) Standard Test Method for Measuring Diameter of Fine Wire by Weighing
1994 ASTM F205-94(2015) Standard Test Method for Measuring Diameter of Fine Wire by Weighing
1994 ASTM F205-94(2010)e1 Standard Test Method for Measuring Diameter of Fine Wire by Weighing
1994 ASTM F205-94(2005) Standard Test Method for Measuring Diameter of Fine Wire by Weighing
1994 ASTM F205-94(1999) Standard Test Method for Measuring Diameter of Fine Wire by Weighing