Full Description 1.1 This specification covers composition, thickness, fabricating procedures, and physical property requirements for glass fiber reinforced thermoset polyester, vinyl ester, or other qualified thermosetting resin laminates comprising the materials of construction for RTP corrosion-resistant tanks, piping, and equipment. This specification is limited to fabrication by contact molding.
NOTE 1—The laminates covered by this specification are manufactured during fabrication of contact molded RTP tanks, piping, and other equipment.
NOTE 2—There is no known ISO equivalent to this standard.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASME NM.3.2-2018 history
1970ASME NM.3.2-2022 Nonmetallic Materials Part 2 - Reinforced Thermoset Plastic Material Specifications
2020ASME NM.3.2-2020 Nonmetallic Materials Part 2 - Reinforced Thermoset Plastic Material Specifications
2019ASME NM.3.2-2018 Nonmetallic Materials, Part 2 - Reinforced Thermoset Plastic Material Specifications