"This test method is intended to determine the moisture content of soils by means of a calcium carbide gas pressure moisture tester. The manufacturer's instructions shall be followed for the proper use of the equipment. The following applies to all specified limits in this standard: For the purposes of determining conformance with these specifications@ an observed value or a calculated value shall be rounded off ""to the nearest unit"" in the last right-hand place of figures used in expressing the limiting value@ in accordance with ASTM E 29. Note 1??This method shall not be used on granular materials having particles large enough to affect the accuracy of the test??in general any appreciable amount retained on a 4.75-mm sieve. The super 200 D tester is intended to be used to test aggregate. The values stated in SI units are to be regarded as the standard. Refer to R 16 for regulatory information for chemicals."
T 217-2002 history
2023T/CIET 217-2023 Grate furnace automatic combustion control system
2014T 217-2014 Standard Method of Test for Determination of Moisture in Soils by Means of a Calcium Carbide Gas Pressure Moisture Tester
2013T 217-2013 Standard Method of Test for Determination of Moisture in Soils by Means of a Calcium Carbide Gas Pressure Moisture Tester
2002T 217-2002 Standard Method of Test for Determination of Moisture in Soils by Means of a Calcium Carbide Gas Pressure Moisture Tester
1996T 217-1996 Standard Specification for Determination of Moisture in Soils by Means of a Calcium Carbide Gas Pressure Moisture Tester (Nineteenth Edition)
1987T 217-1987 Standard Method of Test for Determination of Moisture in Soils by Means of a Calcium Carbide Gas Pressure Moisture Tester