ASTM B100-20 PDF

Scope: 1.1 This specification establishes the requirements for wrought copper-alloy bearing plate and bearing sheets for application in bridges and other structures. Specifically, the plates and sheets are to be used for fixed or expansion bearings where the motion is slow and intermittent with pressures not exceeding 3 ksi (20 MPa). 1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.2.1 Exception—Values given in inch-pound units are the standard except for grain size, which is stated in SI units. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM B100-20 Referenced Document

ASTM B248 Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar
ASTM B846 Standard Terminology for Copper and Copper Alloys
ASTM E10 Standard Test Method for Brinell Hardness of Metallic Materials*， 2023-08-03 Update
ASTM E18 Standard Test Methods for Rockwell Hardness of Metallic Materials*， 2022-05-01 Update
ASTM E255 Standard Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition
ASTM E478 Standard Test Methods for Chemical Analysis of Copper Alloys
ASTM E54
ASTM E62 Standard Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)
ASTM E8/E8M Standard Test Methods for Tension Testing of Metallic Materials*， 2024-01-01 Update
ASTM E9 Standard Test Methods of Compression Testing of Metallic Materials at Room Temperature

2020 ASTM B100-20 Standard Specification for Wrought Copper-Alloy Bearing and Expansion Plates and Sheets for Bridge and Other Structural Use
2013 ASTM B100-13 Standard Specification for Wrought Copper-Alloy Bearing and Expansion Plates and Sheets for Bridge and Other Structural Use
2008 ASTM B100-08 Standard Specification for Wrought Copper-Alloy Bearing and Expansion Plates and Sheets for Bridge and Other Structural Use
2003 ASTM B100-03a Standard Specification for Wrought Copper-Alloy Bearing and Expansion Plates and Sheets for Bridge and Other Structural Use
2003 ASTM B100-03 Standard Specification for Wrought Copper-Alloy Bearing and Expansion Plates and Sheets for Bridge and Other Structural Use
1997 ASTM B100-97 Standard Specification for Wrought Copper-Alloy Bearing and Expansion Plates and Sheets for Bridge and Other Structural Use