ASTM A601/A601M-10(2020) PDF

Scope: 1.1 This specification covers several grades of electrolytic manganese designated as follows: Grade Regular A Intermediate Hydrogen B Low Hydrogen C 4.5 % Nitrogen Bearing D 6 % Nitrogen Bearing E Weld Grade Powder F 1.2 Units—The values stated in either SI units or inchpound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.2.1 This specification is expressed in both inch-pound units and in SI units (within the text, the SI units are shown in brackets); however, unless the purchase order or contract specifies the applicable M specification designation (SI units), the inch-pound units shall apply. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM A601/A601M-10(2020) Referenced Document

ASTM A1025/A1025M Standard Specification for Ferroalloys and Other Alloying Materials, General Requirements
ASTM E11 Standard Specification for Wire Cloth and Sieves for Testing Purposes

2020 ASTM A601/A601M-10(2020) Standard Specification for Electrolytic Manganese Metal
2010 ASTM A601/A601M-10(2015) Standard Specification for Electrolytic Manganese Metal
2010 ASTM A601/A601M-10 Standard Specification for Electrolytic Manganese Metal
2005 ASTM A601-05(2010) Standard Specification for Electrolytic Manganese Metal
2005 ASTM A601-05 Standard Specification for Electrolytic Manganese Metal
1996 ASTM A601-96(2004) Standard Specification for Electrolytic Manganese Metal
1996 ASTM A601-96(2000) Standard Specification for Electrolytic Manganese Metal