ASTM D1370/D1370M-12(2021) PDF

Scope: 1.1 This test method provides a means for evaluating contact compatibility between asphaltic materials. It is generally used to determine compatibility between the saturant and coating used in the manufacture of prepared roofings.2 Coating and saturant will be referred to, but comparable asphaltic materials may be tested where this test procedure seems applicable. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D1370/D1370M-12(2021) Referenced Document

2021 ASTM D1370/D1370M-12(2021) Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test)
2016 ASTM D1370/D1370M-12(2016) Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test)
2012 ASTM D1370/D1370M-12 Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test)
2000 ASTM D1370-00(2007) Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test)
2000 ASTM D1370-00 Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test)