"This test is intended to serve as a rapid test to show the relative proportions of fine dust or claylike material in soils or graded aggregates. The following applies to all specified limits in this standard: For the purpose of determining conformance with these specifications@ an observed value or a calculated value shall be rounded off ""to the nearest unit"" in the last right-hand place of figures used in expressing the limiting value@ in accordance with E 29@ Using Significant Digits in Test Data to Determine Conformance with Specifications. The values stated in SI units are to be regarded as the standard. This standard may involve hazardous materials@ operations@ and equipment. This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use."
T 176-2008 history
2023T/CIET 176-2023 Technical requirements for recycling of waste crystalline silicon photovoltaic modules
2008T 176-2008 Standard Method of Test for Plastic Fines in Graded Aggregates and Soils by Use of the Sand Equivalent Test
2002T 176-2002 Standard Method of Test for Plastic Fines in Graded Aggregates and Soils by Use of the Sand Equivalent Test
2000T 176-2000 Standard Method of Test for Plastic Fines in Graded Aggregates and Soils by Use of the Sand Equivalent Test (Twentieth Edition)
1997T 176-1997 Standard Method of Test for Plastic Fines in Graded Aggregates and Soils by Use of the Sand Equivalent Test (Nineteenth Edition; Revised Per Interim Specifications - Tests and Methods - 1999)
1986T 176-1986 Standard Method of Test for Plastic Fines in Graded Aggregates and Soils by Use of the Sand Equivalent Test