This specification establishes the requirements and test procedures for automotive miniature bulb retention devices@ including wedge base sockets with integral connector@ direct wire wedge base sockets@ circuit plate assemblies@ and associated interfaces. Tests shall follow the sequence shown in the flow charts in Appendix E whenever the following occurs: New design Design@ material or process change made to an existing device@ which could affect the outcome of the test. The test sequence shown in Appendix F shall be run annually. (Note: Production process control data collected at a shorter interval per an approved control plan@ may be substituted if approved by customer's responsible engineer and purchasing representative.)
SAE USCAR15-2006 history
2020SAE USCAR15-4-2020 SPECIFICATION FOR TESTING AUTOMOTIVE LIGHT BULB SOCKETS
2010SAE USCAR15-3-2010 Specification for testing automotive light bulb sockets
2010SAE USCAR15-2010 Specification for testing automotive light bulb sockets
2006SAE USCAR15-2-2006 Specification for Testing Automotive Light Bulb Sockets