ASTM E1920-03(2021) PDF

Scope: 1.1 This guide covers recommendations for sectioning, cleaning, mounting, grinding, and polishing to reveal the microstructural features of thermal sprayed coatings (TSCs) and the substrates to which they are applied when examined microscopically. Because of the diversity of available equipment, the wide variety of coating and substrate combinations, and the sensitivity of these specimens to preparation technique, the existence of a series of recommended methods for metallographic preparation of thermal sprayed coating specimens is helpful. Adherence to this guide will provide practitioners with consistent and reproducible results. Additional information concerning standard practices for metallographic preparation can be found in Guide E3. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E1920-03(2021) Referenced Document

2021 ASTM E1920-03(2021) Standard Guide for Metallographic Preparation of Thermal Sprayed Coatings
2003 ASTM E1920-03(2014) Standard Guide for Metallographic Preparation of Thermal Sprayed Coatings
2003 ASTM E1920-03(2008) Standard Guide for Metallographic Preparation of Thermal Sprayed Coatings
2003 ASTM E1920-03 Standard Guide for Metallographic Preparation of Thermal Sprayed Coatings
1997 ASTM E1920-97 Standard Guide for Metallographic Preparation of Thermal Sprayed Coatings