ASTM E617-18
Standard Specification for Laboratory Weights and Precision Mass Standards

Standard No.

ASTM E617-18

Release Date

2018

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM E617-23

Latest

ASTM E617-23

Scope

1.1 This specification covers weights and mass standards used in laboratories, specifically classes 000, 00, 0, 1, 2, 3, 4, 5, 6, and 7. This specification replaces National Bureau of Standards Circular 547, Section 1, which is out of print. 1.2 This specification and calibration method is intended for use by weight manufacturers, national metrology institutes, weight calibration laboratories, accreditation bodies, users of weights, and regulatory bodies. 1.3 This specification contains the principal physical characteristics and metrological requirements for weights that are used. 1.3.1 For the verification of weighing instruments; 1.3.2 For the calibration of weights of a lower class of accuracy; and 1.3.3 With weighing instruments. 1.4 Maximum Permissible Errors (formerly tolerances) and design restrictions for each class are described in order that both individual weights or sets of weights can be chosen for appropriate applications. 1.5 Weight manufacturers must be able to provide evidence that all new weights comply with specifications in this standard (for example, material, density, magnetism, surface finish, mass values, uncertainties). Statements of compliance by calibration laboratories during subsequent calibrations must meet the requirements of ISO/IEC 17025, 5.10.4.2 and indicate on the calibration report which sections have or have not been assessed. Subsequent calibrations must meet all the requirements (including environmental parameters as shown in Table 11, of Sections 7, 8, and 9; and the requirements of ISO/IEC 17025:2005, 5.10.4.2 to make any claim of compliance to Specification E617, Maximum Permissible Errors, weight classes, or metrological traceability. 1.6 The values stated in SI units are to be regarded as standard. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E617-18 Referenced Document

• ISO/IEC 17025 General requirements for the competence of testing and calibration laboratories [Standard in French]

ASTM E617-18 history

• 2023 ASTM E617-23 Standard Specification for Laboratory Weights and Precision Mass Standards
• 2018 ASTM E617-18 Standard Specification for Laboratory Weights and Precision Mass Standards
• 2013 ASTM E617-13 Standard Specification for Laboratory Weights and Precision Mass Standards
• 1997 ASTM E617-97(2008) Standard Specification for Laboratory Weights And Precision Mass Standards
• 1997 ASTM E617-97(2003) Standard Specification for Laboratory Weights And Precision Mass Standards
• 1997 ASTM E617-97 Standard Specification for Laboratory Weights And Precision Mass Standards