ASTM C943-17 PDF

Scope: 1.1 This practice covers procedures for making standard test cylinders used to determine the compressive strength and density of preplaced-aggregate (PA) concrete. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.2 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM C943-17 Referenced Document

ASTM C125 Standard Terminology Relating to Concrete and Concrete Aggregates*， 2021-10-01 Update
ASTM C192/C192M Standard Practice for Making and Curing Concrete Test Specimens in the Laboratory*， 2019-12-01 Update
ASTM C219 Standard Terminology Relating to Hydraulic and Other Inorganic Cements*， 2024-04-01 Update
ASTM C637 Standard Specification for Aggregates for Radiation-Shielding Concrete
ASTM C937 Standard Specification for Grout Fluidifier for Preplaced-Aggregate Concrete
ASTM C938 Standard Practice for Proportioning Grout Mixtures for Preplaced-Aggregate Concrete
ASTM C939/C939M Standard Test Method for Flow of Grout for Preplaced-Aggregate Concrete (Flow Cone Method)*， 2022-10-01 Update
ASTM C940 Standard Test Method for Expansion and Bleeding of Freshly Mixed Grouts for Preplaced-Aggregate Concrete in the Laboratory

2017 ASTM C943-17 Standard Practice for Making Test Cylinders and Prisms for Determining Strength and Density of Preplaced-Aggregate Concrete in the Laboratory
2010 ASTM C943-10 Standard Practice for Making Test Cylinders and Prisms for Determining Strength and Density of Preplaced-Aggregate Concrete in the Laboratory
2002 ASTM C943-02 Standard Practice for Making Test Cylinders and Prisms for Determining Strength and Density of Preplaced-Aggregate Concrete in the Laboratory
1996 ASTM C943-96 Standard Practice for Making Test Cylinders and Prisms for Determining Strength and Density of Preplaced-Aggregate Concrete in the Laboratory