ASTM D5076/D5076M-13(2019) PDF

Scope: 1.1 This test method includes two procedures for measuring the area of voids in the adhesive between materials used in roofing and waterproofing systems. Both procedures require a count of the number of voids. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D5076/D5076M-13(2019) Referenced Document

ASTM D1079 Standard Terminology Relating to Roofing and Waterproofing*， 2020-05-01 Update
ASTM D2829/D2829M Standard Practice for Sampling and Analysis of Existing Built-Up Roof Systems*， 2023-09-01 Update

2019 ASTM D5076/D5076M-13(2019) Standard Test Method for Measuring Voids in Roofing and Waterproofing Membranes
2013 ASTM D5076/D5076M-13 Standard Test Method for Measuring Voids in Roofing and Waterproofing Membranes
1990 ASTM D5076-90(2006) Standard Test Method for Measuring Voids in Roofing and Waterproofing Membranes
1990 ASTM D5076-90(2000)e1 Standard Test Method for Measuring Voids in Roofing and Waterproofing Membranes