SAE ARP219A-2013 PDF

Scope: This procedure will be generally applicable to three classes of hydraulic components as listed below: Class A-Motors@ Pumps@ Actuators@ Accumulators@ Class B ?C Servo Valves and Metering Valves Class C- Special short Life Duration Components These recommendations are written to cover the following six main categories: 1. Test Circuit (Paragraph). 2. Test Procedure (Paragraph4). 3. Calibration (Paragraph 5). 4. Contamination Test (Paragraph 6). 5. Type and Amount of Contaminant (Paragraph 7). 6. Method of Measuring Contaminant (Paragraph 8). PURPOSE: The purpose of this bulletin is to set forth recommendations of the SAF Committee A-6@ Aerospace Fluid Power Systems and Equipment@ relative to the procedures and methods to be used in conducting contamination controlled tests on aircraft and missile hydraulic systems and pumps. This is for the purpose of outlining a standardized procedure such that comparative results can be obtained.

SAE ARP219A-2013 history

2013 SAE ARP219A-2013 Procedure and Method for Conducting Test of Hydraulic Components in Contamination Controlled System
1992 SAE ARP219-1992 PROCEDURE AND METHOD FOR CONDUCTING TEST OF HYDRAULIC COMPONENTS IN CONTAMINATION CONTROLLED SYSTEM
1961 SAE ARP219-1961 Conducting Test of Hydraulic Components in Contamination Controlled System@ Procedure and Method for