ASTM E1602-03(2017) PDF

Scope: 1.1 This guide covers the design and construction of solid fuel burning masonry heaters. It provides dimensions for site constructed masonry heater components and clearances that have been derived by experience and found to be consistent with the safe installation of those masonry heaters. 1.2 Values given in SI units are to be regarded as standard. Inch/pound units may be rounded (see IEEE/ASTM SI-10). All dimensions are nominal unless specifically stated otherwise. All clearances listed in this guide are actual dimensions. 1.3 This guide applies to the design and construction of masonry heaters built on-site with the components and materials specified herein. It does not apply to the construction/ installation requirements for component systems that have been safety tested and listed. The requirements for listed masonry heater systems are specified in the manufacturer’s installation instructions. 1.4 The design and construction of solid fuel burning masonry heaters shall comply with applicable building codes. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E1602-03(2017) Referenced Document

ASTM C11 Standard Terminology Relating to Gypsum and Related Building Materials and Systems
ASTM C270 Standard Specification for Mortar For Unit Masonry
ASTM C401 Standard Classification of Alumina and Alumina-Silicate Castable Refractories
ASTM C43 Standard Terminology of Structural Clay Products
ASTM C71 Standard Terminology Relating to Refractories*， 2018-10-01 Update
ASTM E136 Standard Test Method for Behavior of Materials in a Vertical Tube Furnace at 750_oC
IEEE/ASTM SI 10 American National Standard for Metric Practice

2017 ASTM E1602-03(2017) Standard Guide for Construction of Solid Fuel Burning Masonry Heaters
2003 ASTM E1602-03(2010)e1 Standard Guide for Construction of Solid Fuel Burning Masonry Heaters
2003 ASTM E1602-03 Standard Guide for Construction of Solid Fuel Burning Masonry Heaters
2001 ASTM E1602-01 Standard Guide for Construction of Solid Fuel Burning Masonry Heaters
1994 ASTM E1602-94 Standard Guide for Construction of Solid Fuel Burning Masonry Heaters