Analysis of the core content of the standard
The standard specifies a complete management and control system for access OTN equipment, mainly including:
- Management and control function architecture: adopts a layered design and implements standardization of southbound interfaces through the NETCONF protocol
- Information model: defines 11 types of core objects and their associations
- Interface operations: supports 28 standard and extended NETCONF commands
Comparison of key technologies
| Technical dimensions | Access OTN | Metropolitan OTN | Differences |
| Management and control interface | NETCONF+SSH | CORBA/TL1 | Lightweight protocol |
| Automatic discovery | Support LLDP | Support OSPF | Simplified discovery protocol |
| DCN requirements | Shared metro DCN | Independent DCN | Network topology differences |
Typical application scenarios
Unified management and control of multi-vendor devices
An operator uses the standard-defined YANG model to implement:
- Connecting devices from different vendors through the NETCONF protocol
- Configuration command conversion based on unified information model
- Alarm data standardization processing efficiency increased by 40%
Implementation suggestions
Device development precautions
- The five basic NETCONF commands specified in Section 6.3.1 must be implemented
- Information model modeling must strictly follow the definition rules in Section 6.2.1
- DCN security requirements must meet all clauses in Chapter 7
Test and verification points
| Southbound interface | Verify that the XML message complies with the naming specification in Appendix B |
| Automatic discovery | Test the link discovery function in Section 8.2 |
Technology evolution analysis
The standard reflects three major technology trends:
- SDN: Using NETCONF/YANG to achieve control separation
- Lightweight: Simplifying the complex management and control functions of metropolitan OTN
- Openness: Breaking vendor lock-in through standard southbound interfaces