Applies to the measurement of partial discharges which occur in electrical apparatus, components or systems when tested with alternating voltages up to 400 Hz or with direct voltage. Defines the quantities to be measured and describes test and measuring circuits which may be used. It is intended that the provisions of this Standard should be used in the drafting of specifications relating to partial discharge measurements for specific power apparatus. This Standard is identical to and has been reproduced from IEC 60270:2000.
RECONFIRMATION NOTICE
Technical Committee EL-007 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been
determined that the publication is still valid and does not require change.
Reconfirmed documents cannot be amended, but may be formally revised and a new
edition published.
Certain documents referenced in the publication may have been amended since the
original date of publication. Users are advised to ensure that they are using the latest
versions of such documents as appropriate, unless advised otherwise in this
Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 18 May 2015.
Reconfirmed documents cannot be amended, but may be formally revised and a new
edition published.
The following are represented on Technical Committee EL-007:
Ausgrid
Australian Industry Group
Energy Networks Association
Engineers Australia
The University of New South Wales
AS 60270:2001(R2015) history
0000 AS 60270:2001(R2015)
2001AS 60270:2001 High-voltage test techniques - Partial discharge measurements