1 This European Standard applies to machines for the manufacture of constructional products of calcium silicate or concrete, where the mould(s) is (are) mounted on a turning or slide moving table. The motive power for compressing the mixture is effected either mechanically (annexes A, B), or hydraulically (annexes C and D). 2 This European Standard deals with the hazards listed in clause 4 of machines for the manufacture of constructional products from concrete and calcium silicate, when used as intended under the conditions foreseen by the manufacturer. This European Standard specifies the appropriate technical measures to eliminate or reduce risks arising from the significant hazards. 3 This European Standard applies to the machines from the point at which the mixture enters the machine (see point 1 of annexes A, B, C, D) and the point where the pallets for concrete products are brought to the assembly (see point 8 at annexes C and D) until the point where the green products are removed from the machine to the curing system (see point 2 of annexes A, B, C, D). 4 This European standard does not cover those requirements for reducing hazards from mechanical, electrical, pneumatic, hydraulic or other equipment or machinery that are dealt with in standards for their common use (Type A, B1 and B2 standards). 5 This European Standard deals with the hazards listed in clause 4 which can arise during the operation and maintenance, including the interfaces, of the slide and turntable machines, when carried out in accordance with the specifications given by the manufacturer or his authorised representative, except noise hazards. NOTE Amendment is under preparation to deal with noise, in particular for measures to reduce noise at source and a noise test code including noise declaration. This standard establishes safety requirements and/or methods of protection which apply to these machines. 6 The provisions stated in this standard assume that all operators have been adequately informed and trained. note:1) Until a noise test code (dealing with the measurement and declaration of noise emission values) specific to the machines covered by this part is available to complement the requirements of 5.7.2 and 7.4.2 of EN 12629-1:2000, it cannot be considered that noise hazards are covered.
BS EN 12629-3:2003 history
2003BS EN 12629-3:2002+A1:2010 Machines for the manufacture of constructional products from concrete and calcium-silicate. Safety. Slide and turntable machines
2003BS EN 12629-3:2002 Machines for the manufacture of constructional products from concrete and calcium-silicate - Safety - Slide and turntable machines