ISO 13232-6:2005
Motorcycles - Test and analysis procedures for research evaluation of rider crash protective devices fitted to motorcycles - Part 6: Full-scale impact-test procedures

Standard No.

ISO 13232-6:2005

Release Date

2005

Published By

International Organization for Standardization (ISO)

Status

Be replaced

Replace By

ISO 13232-6:2005/Amd 1:2012

Latest

ISO 13232-6:2005/Amd 1:2012

Scope

This part of ISO 13232 specifies minimum requirements for: -- paired comparison tests; -- the preparation of the dummy, motorcycle and opposing vehicle; -- the repeatability and reproducibility of impact test conditions within and between test sites; -- the minimization of variation in secondary test variables; -- realistic and representative impact conditions for full-scale impact tests; -- a means to verify analytical evaluations of proposed rider crash protective devices fitted to motorcycles, such as computer simulation. ISO 13232 specifies the minimum requirements for research into the feasibility of protective devices fitted to motorcycles, which are intended to protect the rider in the event of a collision. ISO 13232 is applicable to impact tests involving: -- two-wheeled motorcycles; -- the specified type of opposing vehicle; -- either a stationary and a moving vehicle or two moving vehicles; -- for any moving vehicle, a steady speed and straight-line motion immediately prior to impact; -- one helmeted dummy in a normal seating position on an upright motorcycle; -- the measurement of the potential for specified types of injury by body region; -- evaluation of the results of paired impact tests (i.e. comparisons between motorcycles fitted and not fitted with the proposed devices); -- evaluation of inflatable/triggered protective device. ISO 13232-6 does not apply to testing for regulatory or legislative purposes.

ISO 13232-6:2005 history

• 2012 ISO 13232-6:2005/Amd 1:2012 Motorcycles - Test and analysis procedures for research evaluation of rider crash protective devices fitted to motorcycles - Part 6: Full-scale impact-test procedures - Amendment 1: MATD test helmet
• 2005 ISO 13232-6:2005 Motorcycles - Test and analysis procedures for research evaluation of rider crash protective devices fitted to motorcycles - Part 6: Full-scale impact-test procedures
• 1996 ISO 13232-6:1996 Motorcycles - Test and analysis procedures for research evaluation of rider crash protective devices fitted to motorcycles - Part 6: Full-scale impact-test procedures

Topics on standards and specifications

Standard and Specification