ASTM D1250-04 Adjunct(2019)
Standard Guide for Petroleum Measurement Tables

Standard No.

ASTM D1250-04 Adjunct(2019)

Release Date

2019

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D1250-07

Latest

ASTM D1250-19e1

Scope

This Standard provides the algorithm and implementation procedure for the correction of temperature and pressure effects on density and volume of liquid hydrocarbons which fall within the categories of crude oil, refined products, or lubricating oils; NGLs and LPGs are excluded from consideration in this Standard. The combination of density and volume correction factors for both temperature and pressure is collectively referred to in this Standard as a Correction for Temperature and Pressure of a Liquid (CTPL). The temperature portion of this correction is termed the Correction for the effect of Temperature on Liquid (CTL), also historically known as VCF (Volume Correction Factor). The pressure portion is termed the Correction for the effect of Pressure on Liquid (CPL). As this Standard will be applied to a variety of applications the output parameters specified in this Standard (, 60, T, CTL, Fp Fs, CPL, and CTPL) may be used as specified in other API Manual of Petroleum Measurement Standards (MPMS) Chapters. Including the pressure correction in this Standard represents an important change from the "temperature only" 1980 Tables. However, if the pressure is one atmosphere (the standard pressure) then there is no pressure correction and this Standard will give CTL values consistent with the 1980 Tables. This Standard provides general procedures for the conversion of input data to generate , 60, T, CTL, Fp Fs, CPL, and CTPL values at the user specified base temperature and pressure (Tb, Pb). This section is then followed by two sets of procedures for computing volume correction factor, one set for data expressed in customary units (temperature in °F, pressure in psig), the other for the metric system of units (temperature in °C, pressure in kPa or bar). In contrast to the 1980 Tables, the metric procedures require the procedure for customary units be used first to compute density at 60°F. This value is then further corrected to give the metric output.

ASTM D1250-04 Adjunct(2019) history

• 2019 ASTM D1250-19e1 Standard Guide for the Use of the Joint API and ASTM Adjunct for Temperature and Pressure Volume Correction Factors for Generalized Crude Oils, Refined Products, and Lubricating Oils: API MPMS Chapter
• 2019 ASTM D1250-19 Standard Guide for the Use of the Joint API and ASTM Adjunct for Temperature and Pressure Volume Correction Factors for Generalized Crude Oils, Refined Products, and Lubricating Oils: API MPMS Chapter
• 2008 ASTM D1250-08(2013)e1 Standard Guide for Use of the Petroleum Measurement Tables
• 2008 ASTM D1250-08(2013) Standard Guide for Use of the Petroleum Measurement Tables
• 2008 ASTM D1250-08 Standard Guide for Use of the Petroleum Measurement Tables
• 2007 ASTM D1250-07 Standard Guide for Use of the Petroleum Measurement Tables
• 2004 ASTM D1250-04 Standard Guide for Use of the Petroleum Measurement Tables
• 1980 ASTM D1250-80(2002) Standard Guide for Petroleum Measurement Tables
• 1997 ASTM D1250-80(1997)e1 Standard Guide for Petroleum Measurement Tables
• 0000 ASTM D1250-80